Formulation Calculator

This calculator is for employee use only. CannaClear LLC assumes no liability for the misuse of this calculator.
Percentage Calculator

Formulation / Tincture Calculator

Formulation / Tincture Calculator --- All measurements are calculated in grams and milligrams.
g
EG: 30 for a 30g bottle. This is the size of the bottle the final mixture will go into.
g
Total amount of mixture (EG: 1000 for a 1000 gram batch total)
mg
(EG If making focus tincture, this would be 25 for 25mg desired THCV per 1 gram/ml of oil. If making a 1500mg delta-8 tincture it would be 50 for 50mg per 1ml)
mg
The desired amount of cannabinoids per 1 gram of mixed material. EG: 50 = 50mg of cannabinoids per 1g of mixed material. Same as above so if making focus again, this would be 25 for 25mg CBDV)
mg
The desired amount of cannabinoids per 1 gram of mixed material. EG: 50 = 50mg of cannabinoids per 1g of mixed material. Same as above for tinctures like the relax that also have delta-8 so in this example it would be 30 for 30mg.
%
EG: 99 for 99% CBD isolate. This number will change to a fraction on input for calculation! Same as above but for the 2nd cannabinoid added. So for focus, 99 typically.
%
EG: 99 for 99% CBD isolate. This number will change to a fraction on input for calculation! Same as above, so for relax it would if input 3 was delta-8, it would depend on the batch but typically about 85-95% or lower.
%
EG: 99 for 99% CBD isolate. This number will change to a fraction on input for calculation! (EG: 99 for 99% CBD isolate). For this to be accurate the COA has to be accurate that corresponds to the material batch number.
%
Flavor / Terpene concentration (EG: 3 for 3% or 7 for 7%. This also can be used to calculate terpenes. (Not required). For carts 4-6% is standard depending upon the terpene blend. For most our tincture flavorings it's between 1-3% with some as little as 0.3% so consult the recipe.)

- grams
amount of MCT oil, or other oils that would be needed in grams.

- grams
amount of cannabinoids in grams required to reach desired concentration of batch

- grams
amount of cannabinoids in grams required to reach desired concentration of batch

- grams
amount of cannabinoids in grams required to reach desired concentration of batch

- mg per unit
total MG per each unit

- grams
amount of flavorant/terpenes needed in grams

- mg per unit
total MG per each unit

- total units
maximum total number of units producible assuming zero waste.
Reset Calculator